To connect the board to the user system, follow the instructions below.
2.1.1
Installing the IC Socket
After checking the location of pin 1 on the IC socket fasten it to the user system before soldering.
After confirming the location of pin 1 on the IC socket,
apply epoxy resin adhesive to the end of the four projections
at the bottom of the IC socket, and fasten it to the user
system.
Use the guide pins provided with the product to determine where to install the IC socket, as shown
in figure 2.
4 projections to apply
epoxy resin adhesive to
Bottom view of IC soket
4
CAUTION
Pin 1
User system
Figure 2 Correctly Placing the IC Socket
Guide pins
IC socket
(NQPACK144SD manufactured
by Tokyo Eletech Corporation)