Table of Contents
Advertisement
M30880T-EPB User's Manual
2.9.8 Connecting to a 144-pin 0.5-mm-pitch Foot Pattern
Figure 2.15 shows how to connect the emulation probe to a 144-pin 0.5-mm-pitch foot pattern on the user system with the
M3T-FLX-144NSD (not included), and here following is its procedure. For details on the M3T-FLX-144NSD, refer to its
user's manual.
(1) Attach the NQPACK144SD included with the M3T-FLX-144NSD to the user system.
(2) Attach the YQPACK144SD included with the M3T-FLX-144NSD to the NQPACK144SD.
(3) Insert the YQ-GUIDE's included with the YQPACK144SD to the YQPACK144SD.
(4) Attach the M3T-FLX-144NSD to the YQPACK144SD.
(5) Attach the M30880T-EPB to the M3T-FLX-144SD.
Figure 2.15 Connecting to a 144-pin 0.5-mm-pitch foot pattern
Notes on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator.
The small connectors of the M30880T-EPB and M3T-FLX-144NSD are guaranteed for only 50
insertion/removal iterations.
REJ10J0497-0100Z Rev.1.00 January 16, 2005
*
These corners are not round.
*: These four items are available in one package.
M3T-FLX160-EPB
M30880T-EPB
CN2 side
(5)
M3T-FLX-144NSD
(not included)
(4)
YQ-GUIDE (x4)
YQPACK144SD
(3)
NQPACK144SD
(2)
144-pin 0.5-mm-pitch
(144P6Q) foot pattern
(1)
No. 1 pin
User system
CAUTION
On-board evaluation
HQPACK144SD
(not included)
FLASH MCU etc.
2. Setup
Page 37 of 100
Advertisement
Table of Contents
