Starting Up The Emulator Debugger (Emem Dialog Box) - Renesas Emulation Probe for M32C/87 Group M30870T-EPB User Manual

M30870T-EPB User's Manual

3.2 Starting Up the Emulator Debugger (EMEM Dialog Box)

(1) Status tab
1. Specifying the processor mode
Notes on Selecting a Processor Mode:
When setting single-chip mode or memory expansion mode, the level of pin CNVSS of the MCU status should
be "L". The MCU status shows the pin level of the user system.
When setting microprocessor mode, the level of pin CNVSS of the MCU status should be "H".
When setting memory expansion mode or microprocessor mode, pins RDY* and HOLD* of the user system
should be "H".
When the user system is not connected, all modes are available.
REJ10J0482-0300 Rev.3.00 February 16, 2006
Specifying the processor mode
Select the appropriate processor mode that suits your
system.
IMPORTANT
3. Usage (Emulator Debugger)
Page 57 of 104