Table of Contents
Advertisement
M30870T-EPB User's Manual
(2) Emulation Memory tab
1. Setting the Bank Address of the Debug Monitor
Notes on Setting a Debug Monitor Bank Address:
It is not possible to view or set the content of the specified area. Even on the memory window or in the reverse
assemble area of the program/source windows, the content of this area is not displayed correctly though it can
be displayed.
The below bank addresses cannot be set for the debug monitor.
(1) MCU internal resources (ROM, RAM and SFR areas)
(2) Multiplex areas
(3) Interrupt vector area
REJ10J0482-0300 Rev.3.00 February 16, 2006
Setting the Bank Address of the Debug
Monitor
The debug monitor uses contiguous 64 KB as a work area of
the emulator. Specify the bank address of the debug
monitor.
(e.g.: If D0 is specified, 64 KB area from D00000H address
is used by the debug monitor)
Automatically
Memory of the Internal ROM
When selecting the single-chip mode or memory expansion
mode, an emulation memory is automatically allocated to an
internal ROM area. The automatically allocated addresses of
the internal ROM are shown here.
IMPORTANT
3. Usage (Emulator Debugger)
Allocating
the
Emulation
Page 59 of 104
Advertisement
Table of Contents
