Table of Contents
Advertisement
M30870T-EPB User's Manual
2.9.4 Connecting to a 100-pin 0.65-mm-pitch Foot Pattern (Part 3)
Figure 2.11 shows how to connect the emulation probe to a 100-pin 0.65-mm-pitch foot pattern on the user system with the
M3T-FLX-100NRB (not included), and here following is its procedure. For details on the M3T-100LCC-DMS and M3T-FLX-
100NRB, refer to each user's manual.
(1) Attach the M3T-FLX-100NRB to the user system.
(2) Attach the M3T-100LCC-DMS to the M3T-FLX-100NRB.
(3) Attach the M30800T-PTC to the M30870T-EPB.
(4) Attach the M30800T-PTC to the M3T-100LCC-DMS.
Figure 2.11 Connecting to a 100-pin 0.65-mm-pitch foot pattern (3/3)
Notes on Connecting the User System:
Take care not to attach the converter board in a wrong direction. It may cause a fatal damage to the emulator
and user system.
The small connectors of the M3T-100LCC-DMS and M3T-FLX-100NRB are guaranteed for only 20
insertion/removal iterations.
The small connectors of the M30870T-EPB and M30800T-PTC are guaranteed for only 50 insertion/removal
iterations.
* NQPACK, YQPACK, YQSOCKET, YQ-GUIDE, HQPACK, TQPACK and TQSOCKET are trademarks of Tokyo Eletech Corporation.
REJ10J0482-0300 Rev.3.00 February 16, 2006
*
These corners are not round.
*:These four items are available in one package .
CAUTION
M3T-FLX160-EPB
M30870T-EPB
CN2
(3)
M30800T-PTC
M3T-100LCC-DMS
(not included)
(4)
M3T-FLX-100NRB
(not included)
(2)
The HQPACK100RB cannot be used.
Please use the HQPACK100RB168.
On-board evaluation
YQ-GUIDE(x4)
HQPACK100RB
(not included)
YQPACK100RB
FLASH MCU etc.
NQPACK100RB
100-pin 0.65-mm-pitch
(100P6S) foot pattern
(1)
No. 1 pin
User system
2. Setup
Page 33 of 104
Advertisement
Table of Contents
