Removing Eio Board 2 From Emulator - Renesas H8S/2168 User Manual

2.1.3

Removing EIO Board 2 from Emulator

1. Remove four screws from the side of the emulator station.
2. Pull up and remove the cover of the emulator casing.
×
3. Remove two screws (M2.6 6 mm) from EIO board 2.
4. Remove EIO board 2 from connector P5 of the emulator station.
5. Remove the coaxial cable, which has been connected to EIO board 2, from a gutter of the
emulator station.
6. Set the cover of the emulator station and fasten four screws.
6