Wheel Assembly Rear - Removal; Disc Replacement - TVS Apache RTR 200 4V Service Manual

Warning:
Steering should be adjusted correctly for
smooth movement of handlebar and safe
riding. Stiff steering prevents smooth
movement of handlebar resulting in poor
directional stability and too loose steering
will cause vibration and damage to the
steering races .
Note:
After adjustment, ensure the handlebar
moves smoothly without any jerk or
sticky. When slowly moved by hand it
moves freely from center position to either
left or right with its own weight.

WHEEL ASSEMBLY REAR - REMOVAL

Remove the chain (refer chapter "Periodic
l
maintenance" page no. 2-32 for chain removal
procedure).
Loosen the chain adjusting screw from chain
l
adjuster complete LH and RH.
12 mm spanner
Remove 'U' nut (M14x1.50) from the axle
l
complete rear along with washer. (Fig. 6.81A)
22 mm spanner
Tightening torque
Pull out the axle complete rear by gently
l
tapping at other end. (Fig. 6.81B)
Dislocate the caliper assembly from the slot
l
provided on swing arm complete by pulling it
towards rear side.
Take out wheel assembly rear.
l
Remove the sprocket drum assembly along
l
with spacer rear axle LH from the alloy wheel
rear.

DISC REPLACEMENT

Remove spacer rear axle R. (Fig. 6.82)
l
6-28
CHASSIS
(Fig. 6.80)
78 ± 18 Nm
TVS APACHE RTR 200
Fig. 6.80
Fig. 6.81A Fig. 6.81B
Fig. 6.82
SERVICE MANUAL
A