Rear Wheel Removal And Reassembly - TVS Stryker 125 Manual

MAINTENANCE
1
along with brake panel from the front fork.
6. Separate the brake panel from the wheel and take out
the wheel.
7. In disc brake model, carefully dislocate the disc from the
caliper assembly and slide the wheel out.
8. Reverse the procedure for reassembling.
WARNING
Always make sure that whenever the wheel is removed, axle nut is
properly re-tightened to the specified torque.
In disc brake vehicle, ensure the proper seating of disc in the caliper
assembly while reassembling. Similarly, In drum brake vehicle,
locate the lug on the fork leg L to the slot in the brake panel while
reassembling.

REAR WHEEL REMOVAL AND REASSEMBLY

1. Remove the rear brake adjuster nut (1) and disconnect
the brake rod.
2. Remove the split pin (2) and the nut (3) from the torque
link mounting with the brake panel and disconnect the
torque link.
3. Remove the axle nut (4).
2 4. Pull out the axle (5) and take out the spacer bush from
the rear wheel assembly.
5. Tilt the vehicle to the left and take out the wheel
assembly along with the brake panel.
6. Separate the brake panel from the wheel.
1
4
2
3
5
41