Speed Sensor - TVS Apache RTR 200 4V Service Manual

ELECTRICAL SYSTEM
To inspect the fuel sender unit, fuel tank
l
complete must be removed (refer chapter
"Fuel, lubrication and exhaust system" page
no. 4-1 for removal procedure).
Inspect the fuel sender unit for continuity with
l
pocket tester by connecting '+ve' lead of
pocket tester to green yellow wire (GY) and
'-ve' lead to the black white wire (BW).
Pocket tester
Set pocket tester at 200 ohms position and
l
check the resistance of fuel sender unit. If the
resistance value is not within the specified
limit, replace the sender unit with new one.
(Fig. 5. 32 )
Resistance

SPEED SENSOR

Speed sensor is mounted on the crank case LH
l
near engine sprocket. (Fig. 5.33)
To check the speed sensor:
Set pocket tester at DC 20 V range.
l
Pocket tester
Check and ensure the battery voltage is within
l
the specifications.
Battery voltage
If the battery voltage is found less than the
l
specified voltage, recharge the battery as
explained in page no. 5-26.
Disconnect the speed sensor coupler from the
l
main wiring harness. (Fig. 5.34)
5-14
Full 4 ~ 6 ohms
Empty 108 ~ 112 ohms
12.9 volts
TVS APACHE RTR 200
Fig. 5.32
Fig. 5.33
Fig. 5.34
SERVICE MANUAL
FULL
EMPTY