Rear Wheel Removal - TVS StaR HLX 150 Manual

MAINTENANCE
2. Pull out the axle (2) along with a washer from wheel
assembly.
3. Remove a spacer from right side of the wheel.
4. Place a support (wooden block) below the frame to
revent the vehicle from falling.
5. Lift the front fork assembly up, dislocate the brake panel
along with cables and slide the wheel out.
6. Reverse the procedure for reassembling. Locate the lug
on fork leg L to the slot in the brake panel while
reassembling.

REAR WHEEL REMOVAL

1. Remove the rear brake adjuster (1) and disconnect the
brake rod.
2. Remove the split pin (2) and the nut (3) from torque link
mounting with the brake panel and disconnect the
torque link.
3. Remove the axle nut (4). Pull out the axle (5).
4. Tilt the vehicle to the left and take out the wheel
assembly along with the brake panel assembly.
5. For locating and reassembling the rear wheel easily,
engage gear. This will arrest the free movement of the
drum sprocket.
6. Reverse the procedure for reassembly.
WARNING
Always make sure that whenever the wheel is removed, L and
refitted axle nut is properly retightened to the specified torque and
chain slackness is adjusted to the specified limit.
Once the split pins are removed, replace them with new ones.
39