TVS Apache RTR 200 4V Service Manual page 90

SERVICING OF ENGINE
Gently pull out the sprocket cam shaft using
l
nose plier and dislocate the cam chain from
cam sprocket. (Fig. 3.38)
Caution:
Care should be taken not to drop the cam
chain inside the crankcase assembly while
dislocating.
Hold the cam chain using a good quality copper
l
wire to prevent the chain from falling into the
crankcase assembly and hang it on the head
assembly itself.
Take out the washer camshaft sprocket from
l
the camshaft. (Fig. 3.39)
Nose plier
Take out the cam chain tensioner by removing
l
the bolt cam chain tensioner along with
washer cam chain tensioner. (Fig. 3.40)
12 mm spanner
Tightening torque
Remove the bolt cylinder head (4 nos.) from
l
the mounting of cylinder head complete.
(Fig. 3.41)
12 mm spanner
Tightening torque
Note:
While reassembling, always tighten the
cylinder head assembly bolts in criss-cross
pattern to have uniform seating.
3-12
12 ± 2 Nm
24.5 ± 2.5 Nm
TVS APACHE RTR 200
Fig. 3.38
Fig. 3.39
Fig. 3.40
Fig. 3.41
SERVICE MANUAL