Turn Signal Lamps Front And Rear; Gear Position Sensor - TVS Apache RTR 200 4V Service Manual

ELECTRICAL SYSTEM

TURN SIGNAL LAMPS FRONT AND REAR

The DC output from the ignition lock is
l
connected to the switch turn signal through a
electronic flasher unit mounted below the seat
assembly near the battery. (Fig. 5.25)
The DC output wire orange (Or) from the
l
ignition lock is connected to the flasher unit
and the output from the flasher unit is
connected to the switch turn signal through a
light blue wire (Lbl).
The switch turn signal is located on the switch
l
assembly handle LH. (Fig. 5.26)
Inspect the switch for continuity with the
l
pocket tester.
Pocket tester
SWITCH POSITION
TO LEFT ( )
PRESS RELEASE
TO RIGHT(

GEAR POSITION SENSOR

The gear position sensor is mounted on the
l
crankcase assembly LH below the cover
engine sprocket. (Fig. 5.27)
Gear position sensor senses the exact
l
position of the gear and generates the
resistance accordingly. These resistance are
sent to the digital speedometer and the TCI
unit through a white green wire (WG). To
measure the resistance level of gear position
sensor at various position follow the procedure
given below:
Set the pocket tester at 20k ohms position.
l
Pocket tester
Disconnect the gear position sensor's socket
l
form wiring harness.
Connect pocket tester's '+ve' lead to the
l
green white wire (GW) of gear position sensor
and '–ve' lead to body earth. (Fig. 5.28)
5-12
V LbI
O O
O
) O
TVS APACHE RTR 200
Fig. 5.25
Lg
Fig. 5.26
O
Fig. 5.27
Fig. 5.28
SERVICE MANUAL