Preset Input - Panasonic FP7 User Manual

KEY POINTS
•
For using the Z-phase signal, control signal or comparison match flag as
reset signals, turn on the reset enable request signal using user programs.

5.3.2 Preset Input

The following three preset methods are available.
 Type of reset signals
Preset
Setting method
element
Output Y Activates the preset request signal by a user
relay program.
Input Z Allocates the Z-phase input signal to either preset
signal operation using the configuration menu.
Allocates the control 0 signal to either reset
operation using the configuration menu.
Control 0 Positive logic enable operation and preset
signal operation at rising edge
Negative logic enable operation and preset
operation at trailing edge
 I/O Allocation
Signal name
Preset request
Input Z signal monitor
Control 0 signal monitor
(Note 1): The above I/O numbers are those for the slot number 1 and the starting word number 10. The I/O numbers
actually used vary according to the slot number where the unit is installed and the starting word number.
 Setting of preset values
Unit
memory
Name
No.
（Hex）
UM 00062
UM 00063
UM 00132
UM 00133
Preset
value
UM 00202
UM 00203
UM 002D2
UM 002D3
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Effective
condition
ON edge
-
-
Default
Set preset values.
Setting range:
0
-2,147,483,648 （8000 0000H） to 2,147,483,647 （7FFF FFFFH）
Signed 32-bit
Preset condition
ON
OFF



CH0
Y103
X10A
X10B
Setting range and description
ON ON ON
OFF OFF OFF
 

CH1 CH2 CH3
Y113 Y123 Y133
X12A X14A X16A
X12B X14B X16B

Unit
Pulse