Abit IT7-MAX2 User Manual page 39

Hardware Setup
(6). FPIO2: Front panel audio connection header
This header provides the connection to audio connector at front panel.
•
To use the audio connector at front panel, remove all the jumpers on this header, and then
connect to front panel via an extension cable.
•
To use the audio connector at rear panel, disconnect the extension cable, attach the jumpers back
at pin 5-6, and pin 9-10 (default setting).
Pin
1 Audio Mic.
3 Audio Mic. Bias
5 Speaker Out Right Channel
7 X
9 Speaker Out Left Channel
11 GND
13 VCC
Pin Assignment Pin Pin Assignment
2 GND
4 VCC
Speaker Out Right Channel
6
Return
8 NC
10 Speaker Out Left Channel Return
12 S/PDIF In
14 S/PDIF Out
2-7
User's Manual