Important Safety Instructions; General Owner's Instructions - Kasco 8400JF Owner's Instructions Manual

J series decorative aerators
Table of Contents

Advertisement

THANKS
We at Kasco Marine, Inc. would like to both thank and
congratulate you on your purchase of the JF model
decorative aerator. We appreciate you choosing Kasco
and for your purchase. Your decision to purchase Kas-
co's Decorative Aerator will not disappoint you. The
JF Series Decorative aerator will be a great addition
to your body of water. It will help improve the water
quality by adding much needed oxygen and circula-
tion. It will also enhance the aesthetics of the pond or
lake with beautiful patterns. The lighting package (if
purchased) will illuminate your aerator for beauty day
and night. We thank you for choosing Kasco for your
aerator needs and want you to be completely satisfied
with your purchase.

Important Safety Instructions

Please read and follow these extremely important
safety and handling instructions for your Kasco equip-
ment. Following these instructions will help ensure
your safety and the quality performance of your equip-
ment.
• Under NO circumstances should anyone enter the
water with the electrical equipment plugged in and/
or in operation. All Kasco equipment is ETL ap-
proved to UL and CSA standards for safety in water.
However, it is NEVER recommended to enter the
water with the equipment in operation.
• Caution should be used when dealing with any elec-
trical and/or moving equipment.
• NEVER run the unit out of water. It will damage the
seals and create a dangerous situation for the opera-
tor.
• Extreme caution should be used around water, espe-
cially cold water, such as in Spring, Fall, and Winter.
Cold water poses a hazard in and of itself.
• NEVER lift or drag the aerator by the power or light
cord. If you need to pull the unit to the side of the
pond, use the anchoring ropes.
• Do not use waders in deep ponds/lakes or ponds/
lakes with drop-offs, drastic slopes, or soft bottom
material.
• Do not use boats that tip easily for aerator installa-
tion , such as a canoe, and follow all boating safety
rules and regulations, including wearing a PFD (Per-
sonal Flotation Device).
• Single phase aerators (8400, 3.1, and 5.1JF ) are sup-
plied with an internal grounding conductor and/or a
grounding-type attachment plug. To reduce the risk
of electrical shock, be certain the aerator is properly
connected to the Kasco supplied control panel. (re-
2
fer to the C-85 & C-95 Control instruction)
• 3 phase aerators (2.3, 3.3, 5.3, 7.3JF) require a
startup test after wiring to ensure proper rotation of
the impeller. If the impeller is rotating in the oppo-
site direction, the unit will not perform properly and
internal damage to the unit may occur. (See 3 phase
startup procedure)
• Control panels must be installed a minimum of
5ft(3m in Canada) from the inside wall of the pond,
unless separated from the body of water by a fence
wall, or other permanent barrier that will make the
unit inaccessible to persons in the water.
• Control panels must be installed by a qualified elec-
trician.
• Ground Fault Circuit Interrupters (GFCI) should be
tested upon each installation and every month there-
after to ensure proper operation.

General Owner's Instructions

INSPECT THE SHIPMENT
Immediately inspect your Kasco aerator shipment for
any visible damages. Also cross reference the parts
supplied with the Parts Included sheet to check for
shortages. Shortages should be reported immediately
to your Kasco Marine distributor or representative and
damages reported to your carrier and Kasco Marine.
ASSEMBLY & INSTALLATION
Please see the proper Assembly and Installation In-
structions enclosed in this manual. Each is specific
for your model and size of aerator. Note: Use a nylon
tie to help keep the power cords for the unit and lights
free of the impeller by tying each cord to either side of
the float. If you have a light kit, make sure that the unit
cord is tied to one side of the float and the light cord to
the other for balance. Note: It is extremely important
to test the GFCI in the control panel upon each instal-
lation/reinstallation of the unit to ensure proper func-
tioning.
USE AND OPERATION
Kasco Aerators are designed and engineered for
continuous duty, such as on fish farms or other aqua-
culture applications, or on-demand use, as needed in a
recreational water feature.
During flotation operation, the water is pulled from
360
O
around the unit and from below the unit. The
water is pulled upward and thrust through the flotation
collar into the air.

Advertisement

Table of Contents
loading

This manual is also suitable for:

3.1jf5.1jf

Table of Contents