Kasco 8400JF Owner's Instructions Manual page 6

Attach 3 cable ties
to top ring equally spaced
2 inch overlap
Flip mesh and screen assembly over and use
remaining cable ties to secure mesh to small bottom
diameter of the stainless steel ring.
to bottom ring equally spaced
Clip off excess cable tie material once mesh is secured
into place.
Position the Bottom Screen (Part #B6) over the float
so the motor housing (can) passes through the large
hole in the center of the screen. Remove the center
three 3/8" Lock Nuts from the 9" Bolts and place the
6
Attach 2 cable ties
Bottom Screen Clips (Part #B12) over the bolts as
shown. The power cord can be slid under the bottom
screen between the float and screen where two float
sections come together before the 3/8" Lock Nuts
are replaced. Replace the three inside Lock Nuts and
tighten all 3/8" Lock Nuts using the 9/16" wrench and
socket.
8. Return the unit to its upright position and select a
nozzle (See Nozzle and Pattern Options). Insert the
Shaft Bolt (Part #D2) into the Nozzle Head so it fits
snugly into the molded socket for those nozzles that
use the bolt. Install the Nozzle by threading it into
the inner cone of the pump. Make sure to tighten the
Nozzle all the way down.
NOTE: If the nozzle does not look centered, see the
steps in the troubleshooting section for adjusting
the inner cone that the nozzle screws into.
To install the Redwood nozzle, make sure the Y Insert
(Part #D4) is installed and seated properly into the
Nozzle Housing (Part #D7). Push the nozzle down
over the cone assembly (it may require light taps with
a rubber mallet to seat properly). Next, use the 3 Self
Tapping Screws (Part #D1) provided in the 3 holes on
the nozzle and tighten the screws into the cone as-
sembly. Once you feel resistance, two more turns will
be sufficient. To install the Spruce nozzle, follow the
same steps, but do not install the Y Insert.