Kasco 8400JF Owner's Instructions Manual page 5

3. Position one Top Float Bracket (Part #B2) so that
the bolt holes in the bracket align with the bolt holes
in the two adjoined float sections and insert two 9.5"
Coated Bolts (Part #B4) through the assembly. This
may require some minor repositioning of the float sec-
tions as you push the bolt all the way through. Do not
force the bolt through. Repeat for the remaining two
joints.
4. Turn the assembly upside down and place the Bot-
tom Float Brackets (Part #B3) over the bolts, the ends
of which should now be extending through the assem-
bly. Loosely install the six 3/8" Lock Nuts (Part #B5)
on the ends of the bolts (do not tighten yet).
5. Rest the float on the base plate of the unit. Connect
the float to the base plate using the 3/8" x 1" bolt (Part
#B13) and 3/8" lock washer (Part #B14). Tighten us-
ing a 9/16" wrench.
6. Center the Top Screen (Part #B7) inside the three
Top Float Brackets. Attach the screen by spanning
each Top Screen Clip (Part #B8) across the two
innermost rings on the screen and the hole in the float
bracket. Insert the 3/4" Brass Screws (Part #B9) and
attach with 1/4" Lock Washers (Part #B10) and 1/4"
Nuts (Part #B11) to secure the screen to the float
assembly.
7. Take flat mesh pattern and wrap into cone shape by
overlapping both vertical edges by approximately 1
inch and aligning top and bottom edges of mesh. Se-
cure mesh vertical seam at the top, bottom and middle
using (3) cable ties.
Place mesh cone on flat surface with small diameter at
bottom. Insert existing stainless steel screen centered
inside mesh cone with approximately 2 inches of mesh
overlap to the top ring of the screen. Attach mesh
to the top ring of the screen in (3) equally spaced
locations using cable ties.
Overlap vertical edges
Attach 3 cable ties
1 inch overlap
5