Ramp/Soak Time Units; Setting Ramp/Soak Sv, Ramp Time And Soak Time - FujiFilm PXG4 Operation Manuals

Ramp/Soak Time Units

The following sets the ramp/soak time units for ramp/
soak activation.
Select one of the following:
• Range hh : MM(hour:min)
MM : SS(min:sec)
Time units cannot be set separately for each step.
Point
All steps use the same unit of time.

Setting Ramp/Soak SV, Ramp Time and Soak Time

Press and hold the
1
mode channel menu ("o o o o P P P P E E E E C C C C h h h h 1 1 1 1 "), then use the
keys to display PrG ("P P P P L L L L T T T T C C C C h h h h 4 4 4 4 ").
Refer to
See p. 56 in this chapter for information on how to display
the operation menu.
Press and hold the
2
keys to display TiMU ("T T T T i i i i M M M M U U U U ").
Select the ramp/soak time units.
Press the key, then use the
3
select "hh.MM" when the bottom part of the
display begins to blink.
Ramp/soak time unit is set to "hr:min".
Press the key to confirm the setting.
4
Press the key to return to the operation mode
5
PV/SV display.
key to display the setup
key, then use the
keys to
– 57 –
Chapter
6