Display Timeout Settings; Setting The Display Timeout - FujiFilm PXG4 Operation Manuals

Display Timeout Settings

This section explains how to set the time that the device
waits for input before returning from monitor or setup
mode (channel or parameter display) to PV/SV display.
• Range 15S : 15 sec
30S : 30 sec
60S : 60 sec
5M : 5 min
10M : 10 min
non : Do not return
(change
operation mode
mode)
initial display
hold down
(PV/SV display)
hold down
observation
value display
hold down
channel menu
hold down
parameter
menu
manual mode
manual output
(PV/MV display)
(change
display only)
only during manual mode
manual lamp ON
monitoring mode
: Press several times
setup mode
channel display
parameter display
parameter
setting

Setting the Display Timeout

This section explains how to set the display timeout by using
10 min as an example.
Operation mode
Press and hold the
1
The monitoring mode MV1 is displayed.
Press and hold the
2
mode channel menu ("o o o o P P P P E E E E C C C C h h h h 1 1 1 1 "), then use the
keys to display CFG ("C C C C F F F F G G G G C C C C h h h h 1 1 1 1 3 3 3 3 ").
Press and hold the
3
keys to display ToUT ("T T T T o o o o U U U U T T T T ").
Press the
4
select "10M" when the bottom part of the display
begins to blink.
The display timeout is set to 10 minutes.
Press the
5
Press the
6
PV/SV display.
– 143 –
key to display "n n n n v v v v 1 1 1 1 ".
key to display the setup
key, then use the
key, then use the
key to confirm the setting.
key to return to the operation mode
keys to
Chapter
15