Changing Pid No; Changing The Pid No; Alarm Settings; Setting Key Lock - FujiFilm PXG4 Operation Manuals

Changing PID No.

The following changes a previously set PID No.
This allows you to change the PID No. to fit the SV and
control settings.
• Range: Pid0, Pid1 ... Pid7, DI

Changing the PID No.

Press and hold the
1
menu of the setting mode, then use the
keys to display "o o o o P P P P E E E E C C C C h h h h 1 1 1 1 ".
Refer to
See p. 23 in this chapter for information on how to display
the channel menu.
Press and hold the
2
keys to display PLn1 ("P P P P L L L L n n n n 1 1 1 1 ").
The PID No. is changed.
Press the key, then use the
3
display "Pid1" when the bottom part of the
display begins to blink.
In this example, change to "Pid1".
Press the key to confirm the setting.
4
The PID calculation parameter used for control will
change from PID0 to PID1.
Press the key to return to the PV/SV display
5
of the operation mode.
key to display the channel
key, then use the
keys to
– 27 –

Alarm Settings

The following steps set the values for ALM1 to ALM5
when DO1 to DO5 are set as alarms.
• Range: 0% to 100% FS
Refer to
See "Chapter 10 Alarm Parameters (Ch8)" (p. 107) for more
information on delay time and alarm detection hysteresis

Setting Key Lock

Press and hold the
1
menu of the setting menu, then use the
keys to display "o o o o P P P P E E E E C C C C h h h h 1 1 1 1 ".
Refer to
See p. 23 in this chapter for information on how to display
the channel menu.
Press and hold the
2
keys to select AL1 ("A A A A L L L L 1 1 1 1 ").
The alarm value for ALM1 is set.
Press the key, then use the
3
display "50.0" when the bottom part of the display
begins to blink.
The alarm value is now set to "50°C".
Press the key to confirm the setting.
4
ALM1 alarm value is set to "50.0°C".
Repeat steps 2 to 4 (except pressing and holding
5
the key) to set through ALM5.
Press the key to return to the PV/SV display
6
of the operation mode.
key to display the channel
key, then use the
keys to
Chapter
3