Output Convergence Value; Setting The Output Convergence Value - FujiFilm PXG4 Operation Manuals

Output Convergence Value

Output convergence value is a function that adds MV
value offset.
• Range bAL : -100% to 100%
● The output convergence value function ("b b b b A A A A L L L L ") outputs to
PV and SV a calculated result of the PID computed MV
plus the bAL offset.
(The factory setting of bAL is 0% for single output, 50% for
dual output.)
bAL=0%
40%
proportional
band
MV
100%
50%
bAL=40%
SV
PV

Setting the Output Convergence Value

Press and hold the
1
mode channel menu ("o o o o P P P P E E E E C C C C h h h h 1 1 1 1 "), then use the
keys to display Pid ("P P P P i i i i d d d d C C C C h h h h 2 2 2 2 ").
Refer to
See p. 31 in this chapter for information on how to display
the channel menu.
Press and hold the
2
use the
Set the output convergence value.
Press the
3
the output convergence value to "3.0".
The output convergence value is set to 3.0.
Press the
4
Press the
5
PV/SV display.
– 35 –
key to display the setup
key to display P ("P P P P ") then
keys to display bAL ("b b b b A A A A L L L L ").
key, then use the keys to set
key to confirm the setting.
key to return to the operation mode
Chapter
4