Sega TARGET BRAVO Operators & Service Manual page 3

• Specification changes (removal of equipment, conversion and addition) not
designated by SEGA are not allowed.
The parts of the product include warning labels for safety, covers for personal protection, etc. It is very
hazardous to operate the product by removing parts and/or modifying the circuits. Should doors, lids and
protective parts be damaged or lost, refrain from operating the product, and contact where the product
was purchased from or the office herein stated.
SEGA shall not be held responsible for any accidents, compensation for damage to a third party,
resulting from the specifications not designated by SEGA.
Ensure that the product meets the requirements of appropriate electrical
•
specifications.
Before installing the product, check for electrical specifications. SEGA products have a nameplate on
which electrical specifications are described. Ensure that the product is compatible with the power supply
voltage and frequency requirements of the location. Using any electrical specifications different from the
designated specifications can cause a fire and an electric shock.
Install and operate the product in places where appropriate lighting is available,
allowing warning labels to be clearly read.
•
To ensure safety for the customers, labels and printed instructions describing potentially hazardous
situations are applied to places where accidents can be caused. Ensure that where the product is operated
has sufficient lighting allowing the warnings to be read. If any label is peeled off, apply it again
immediately. Please place an order with where the product was purchased from or the office herein stated.
When handling the monitor, be very careful. (Applies
only to products with monitors.)
Some of the monitor parts are subject to high tension voltage. Even after turning off the power, some
•
portions are still subject to high tension voltage sometimes. Monitor repair and replacement should be
performed only by those technical personnel who have knowledge of electricity and technical expertise.
Be sure to adjust the monitor properly.
(Applies only to products with monitors.)
Do not operate the product leaving on-screen flickering or blurring as it is. Using the product with the
monitor not properly adjusted may cause dizziness or a headache to an operator, a player, or the
customers.
•
When transporting or reselling this product, be sure to attach this manual to the
product.
* In the case where commercially available monitors and printers are used in this product, only the
contents relating to this product are explained herein. Some commercially available equipment
has functions and reactions not stated in this manual. Read this manual together with the specific
instruction manual of such equipment.
*
Descriptions herein contained may be subject to improvement changes without notice.
* The contents described herein are fully prepared with due care. However, should any question
arise or errors be found, please contact SEGA.
INSPECTIONS IMMEDIATELY AFTER TRANSPORTING THE PRODUCT TO THE LOCATION
Normally, at the time of shipment, SEGA products are in a status allowing for usage immediately
after transporting to the location. Nevertheless, an irregular situation may occur during
transportation. Before turning on the power, check the following points to ensure that the product
has been transported in a satisfactory status.
Are there any dented portions or defects (cuts, etc.) on the external surfaces of the cabinet?
Are casters and adjusters damaged?
Do the power supply voltage and frequency requirements meet with those of the location?
Are all wiring connectors correctly and securely connected? Unless connected in the correct way,
connector connections can not be made accurately. Do not insert connectors forcibly.
Do power cables have cuts and dents?
Are all accessories available?
Can all doors and lids be opened with the accessory keys? Can doors and lids be firmly closed?