Sega TARGET BRAVO Operators & Service Manual page 65

7-5 NRI OPTIONS - TEACH AND RUN PROGRAMMING
TEACH AND RUN PROGRAMMING (NRI)
If the machine is positioned in location where only tokens are used, then the NRI Coin Acceptor can be programmed
to accept and credit special coins/tokens.
Please follow the instructions below to enable and program the TEACH & RUN facility.
TEACHING COIN CHANNELS USING TEACH MODE
In order to generate new acceptance bands you can teach up to eight coin channels using the lower switching block
on the coin validator. You will need at least ten coins of the new type. There is a different switch assignment for
the double and single block data-management:
Switching block S2 (with double block data-management)
DIL switch
S2.1 Coin channel 9
S2.2 Coin channel 10
S2.3 Coin channel 11
S2.4
Coin channel 12
S2.5 Coin channel 13
S2.6 Coin channel 14
S2.7 Coin channel 15
S2.8
Coin channel 16
S2.9 Teach mode
S2.10 Acceptance band
By default, the eight teach channels have been programmed, so that one coin impulse is transmitted to the machine
via coin signal line 6, when a new coin is accepted.
on
off
teach
teach
teach
teach
teach
teach
teach
teach
switch off switch on
normal wide