Table of Contents
Advertisement
Getting
Started
Installing the battery
The 4200 FlexScan FTIR comes with two lithium-ion batteries, which
are fully charged. Each battery gives approximately 4 hours of run
time. A battery charger is also included; refer to the battery charger
manual for information on its operation. There is an LCD display on
the front of the battery indicating the level of charge. Five (5) bars
indicate a full charge.
The 4200 FlexScan FTIR has a door on the front of the handle. The
door on the front gives access to the system battery. The door must
remain closed and locked while the system is in use. The 4200
FlexScan should arrive with one battery in the shipping case.
To install the battery:
1
2
3
4
5
Depending on temperature and age of the battery, the system should
generally operate for a period of four hours on battery power.
To remove the battery from the compartment, open the door and pull
on the black plastic tab to slide the battery out of the 4200 FlexScan
FTIR housing.
12
Release the battery door tab on the top of the electrical housing
(see Figure 1).
Slide the battery into the compartment with the tab of the battery
facing downward and towards the front side of the 4200
FlexScan FTIR. The V-grove on the top of the battery interfaces
with the tab on the top of the battery compartment.
Slide the battery towards the back of the compartment until you
feel the battery engage.
Continue to slide another eighth of an inch until completely
engaged. If the battery is not fully engaged, the system will not
operate properly.
Close the battery compartment door.
Agilent 4200 FlexScan FTIR Operation Manual
Advertisement
Table of Contents
