Table of Contents
Advertisement
Getting
Started
2
If a 2.4 GHz cordless phone or a cellular telephone is used near the 4200
CAUTION
FlexScan FTIR, you may experience problems with the wireless communication
and spectroscopic performance. Try turning off the phone or moving further away
from the instrument and attempt the application again.
Performance verification
The 4200 FlexScan FTIR spectrometer systems have been thoroughly
tested at the factory, so no alignment steps are required. However, it
is recommended to run the performance test initially to ensure the
instrument is running properly. To run and interpret the
performance test, refer to the MicroLab Software Operation Manual.
The performance test measures the energy level of the instrument
(based on the interferogram voltage or height). A successful test will
be indicated by a green circle at the top of the software screen. You
are now ready to analyze a sample. A yellow or red circle indicates
the instrument is operating outside of the factory-defined
parameters. These parameters are listed below as well as on the
Advanced Features software page.
If the circle at the top of the software screen is yellow or red, contact Agilent
NOTE
technical support for assistance.
16
For detailed instructions on initial software logon and user
management, refer to the MicroLab Software Operation Manual.
For additional instructions on adding a user to the system and
other initial software setup procedures, refer to the MicroLab
Software Operation Manual.
Agilent 4200 FlexScan FTIR Operation Manual
Advertisement
Table of Contents
