Memory Switches - Epson TM-P60 Technical Reference Manual

2. To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and
then pull it upward to release the projection.)
DIP switch
Handshake
DTR/DSR
RTS/CTS
DSW 1 is fixed to OFF.
Note:
Serial communication setting is assigned to MemorySwitch (baud rate, parity). See the table " Customize
values" (page 2-16) for details.
3. After set the DIP switch, attach the DIP switch cover.

2.7.3 Memory Switches

This printer has a set of software switches called "Memory switches" . The memory switch set
has "Msw 8," "Customize value," "Serial communication condition."
The "Memory switch setting utility" can change the Memory switch set to ON or OFF as shown
in the table below:
Note:
When you use this printer with RS-232C interface, you should adjust the "serial communication setting"
(see the table " Serial communication" (page 2-17).)
Rev. C
projection
DIP switch
DSW1 DSW2 DSW3
OFF ON OFF
OFF OFF ON
TM-P60 Technical Reference Guide
DIP switch cover
DSW4
ON
OFF
Setup 2-15