Epson TM-P60 Technical Reference Manual page 40

The Memory switch can be changed by either one of two methods:
• Memory switch setting utility
• Control by an ESC/POS command
Settings of the memory switch are stored in the NV memory; therefore, even if the printer is turned off, the
settings are maintained. Excessive use of this function may destroy the NV memory. As a guideline, do
not use this function more than 10 times a day.
Memory Switch 8
SW Function
1 Status notice *1
2 Beeper tone when the battery is low
3 Beeper tone when this printer can't
connect to any access point
4 Beeper tone when roll paper is out
5 Beeper tone when an error occurs
6 ~ 8 Reserved
* : Default setting
Note:
Msw 8-1:
When On is selected, this printer transmits power-off notice, power-on notice, and battery status to a host
PC. When off is selected, this printer doesn't transmit these.
Msw 8-2:
When On is selected, the printer beeps the buzzer for 10 seconds when the battery status enters "battery
level is L" or "battery level is S."
Msw 8-3, 8-4, 8-5:
When On is selected, the buzzer beeps for 10 seconds for each situation. For information on printer errors
(Msw 8-5), see "3.1.1 Error Types" (page 3-1).
Customize values
Function
Roll paper width
Time for auto power off
Print density
* "Time for auto power off": When a printer isn't received any data from host PC, and isn't operated anything (ex.
opening the roll paper cover, pressing the FEED button) during the specified time, the printer turns off itself
automaticaly.
Note:
See "2.7.5 Adjusting Roll paper width" (page 2-23) also to adjust roll paper width.
2-16 Setup
On
Transmit s*
Beeps *
Beeps *
Beeps *
Beeps *
-
Selectable value
58mm or 60 mm (Default: 58mm)
Disable, or 1 ~ 60 minutes (Default: 20 minutes)
70%, 75%, 80%, 85%, 90%, 95%, 100%, 105%, 110%, 115%, 120%,
125%, 130%, (Default: 100%)
Off
Doesn't transmit
Doesn't beep
Doesn't beep
Doesn't beep
Doesn't beep
Fixed to Off *
Rev. C