Bluetooth Connection; Bluetooth Connection Overview - Epson TM-P60 Technical Reference Manual

Bluetooth interface model

Hide thumbs Also See for TM-P60:

Table of Contents

2.6 Bluetooth Connection

The procedures for connecting the host device to the TM-P60 using Bluetooth are indicated

below. The TM-P60 uses SSP (Serial Communication Protocol) to create the Bluetooth

connection. A Bluetooth-compatible PDA is used as an example for connecting via Bluetooth. In

order to print, you must install a PDA printer application on the PDA.

Follow the PDA Bluetooth setup tool instructions for setup operations. One example is indicated

below. Use your host device manual for actual operations.

PDA Preparation

Confirm that your PDA is a Bluetooth-compatible device. Some devices may require installation

of a Bluetooth module and software.

Turn printer power on

Start the Bluetooth Setup Tool

Detect communication-ready Bluetooth devices

Select the TM printer from the list of communication-ready devices

Enter passkey

Confirm the profiles that can be used

Setup finished

Since the output of Bluetooth radio waves is limited, communication can be affected by the

setup location, direction installed, other devices in the area, etc., which may disrupt or decrease

the speed of communication. As a result, make sure to thoroughly check device operation prior

to using.

Establish the Bluetooth connection by using the PDA's Bluetooth setup tool. Set up the

connection by following the direction indicated by this tool.

2-12 Setup

Rev. C

Table of Contents