2.6.7 Confirming the profiles that can be used
Use the Bluetooth setup tool to confirm the Bluetooth profiles that can be used. The TM-P60
supports only "SPP" (virtual serial communication).
Note:
"Service" may be displayed as the profile.
2.6.8 Completing the Bluetooth Connection
The Bluetooth connection is complete once all setting are completed with the Bluetooth setup
tool.
Once communication with a device has been established, some PDAs add a connection icon to
their screen. This allows the user to re-establish connection by clicking the icon.
2.7 Adjusting Various Settings
This printer is able to be adjusted for the items below:
❏ DIP switch (handshake of serial communication conditions)
❏ Memory switch (buzzer on/off, status notification, serial communication conditions, paper
roll width, print density, Bluetooth passkey and device name, other)
❏ Roll paper width (58mm / 60mm)
❏ Change the Bluetooth passkey and device name.
The current settings can be confirmed by a self test. (See "3.5.1 Self test mode" (page 3-3).)
Note:
When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings
by running a self-test. See "3.5.1 Self test mode" (page 3-3) for detail.
2.7.1 How to Confirm Current Settings
You can use a self-test to confirm the current settings. See "3.5.1 Self test mode" (page 3-3).
2.7.2 DIP switch
This printer has DIP switches 1~4. These are located as shown in the figure below.
1. Make sure the printer is turned off.
2-14 Setup
Adjusting the spacer and memory switch
Rev. C