2.3 Setting up the Printer
The TM-P60 can be set up as indicated below.
❏
Attached to a belt. If you do so, you don't need to follow any further printer setup
instructions.
❏
Attached to a shoulder strap and carried on your shoulder.
❏
Set up on a table. Remove the belt clip if you do so.
2.3.1 Attaching the Shoulder Strap
Attach the shoulder strap by following the procedures
indicated on the right.
CAUTION:
Make sure to hang the shoulder strap only from
your shoulder. In order to prevent injury, never
hang it from your neck.
Make sure the paper roll side is facing down when
using the device vertically.
2.3.2 Setting Up on a Table
Remove the belt clip on the back when setting up on a
table. Remove the two screws shown in the diagram.
CAUTION:
Make sure to place the device on a horizontal
surface when setting up on a table.
Rev. C
TM-P60 Technical Reference Guide
screws
belt clip
Setup 2-5