Additional Information; Default Settings - Air Lift Performance 3P Installation Manual

Additional Information

PRESET MODES
There are three standard preset modes used in
this system. If the user chooses, the all-up and
all-down buttons can be set as two additional
presets which will follow the same requirement
for operation below (see page 9).
Presets are viewed, used and changed/saved
with the following procedures:
1. Press the appropriate
preset key once to display
current preset values.
2. Double press the preset key
to obtain the preset value
that is currently saved.
3. Press and hold the preset
key to change the preset value.
CHANGING PRESETS
1. Press and hold the preset key you want to
change. The display will allow you to manually
change those values using the corner keys.
(Values will be shown as PSI for pressure and
percentage for height).
2. Press and hold the preset key again to save
your selected values.
3. To exit without saving the current preset, press
any other preset button at any time.

DEFAULT SETTINGS

1. Preset low – 25 PSI (pressure)/ 25% (height)
2. Preset ride – 50 PSI (pressure)/ 50% (height)
3. Preset high – 75 PSI (pressure)/ 75% (height)
WARNING
threshold, then start driving. The 3H/3P system is
a universal system and settings will be different for
every user and vehicle.
18
User-defined preset
User-defined preset
It is possible to set the vehicle
at a height that is below
the minimum drive height
3H/3P User Guide
Preset high
Preset ride
Preset low
MN-948