Compressor (Optional) - Air Lift Performance 3P Installation Manual

Installation Manual

COMPRESSOR (OPTIONAL)

1. Prepare the compressor intake. If it is mounted inside the vehicle, attach the filter to
2. Center-punch and drill four holes using the compressor or the template on page 29.
3. Secure the compressor using the supplied hardware (see installation diagram).
Filter attached
to compressor
NOTE
NOTE: If using an Air-Zenith compressor see figure 33 on page 21.
MN-946
port on end of compressor (fig. 14). If the compressor is located outside the vehicle,
snorkel the inlet filter to dry location inside vehicle using components supplied with
compressor (fig. 15).
COMPRESSOR
MOUNTING
HARDWARE
Filter snorkeled
inside of vehicle
to reduce
moisture drawn
into the tank.
Mounting bolt
Flat washer
Compressor foot
Rubber bushing
Mounting surface
Flat washer
Lock washer
Nut
Compressor
mounted under
vehicle
fig. 14
fig. 15
11