Air Lift Performance 3P Installation Manual page 51

3H/3P User Guide
Calibration, Cont.
WIZARD
13. Height Sensor Calibration (Upper)
a. If Auto Sensor Calibration was
selected, the system will cycle the
suspension to calibrate its upper limit
position.
b. If Manual Calibration was selected,
the system will now ask for the user
to set the "Upper Limits." Do this by
using the manual buttons to raise
the suspension to its highest setting
on all four corners. Press the middle
button when complete.
14. Height Sensor Calibration (Lower)
a. If Auto Sensor Calibration was
selected, the system will now cycle
the suspension to calibrate its lower
limit position.
b. If Manual Calibration was selected,
the system will now ask for the user
to set the "Lower Limits." Do this by using the manual
buttons to lower the suspension to its lowest setting
on all four corners. Press the middle button when
complete.
15. System will now check Height Sensor vehicle wiring (Only
completes this if user selected Auto Sensor).
16. The system will now perform a movement calibration for
height mode.
17. Once it has run through the calibration wizard successfully, it
will say "Calibration Successful" and the system will then be
ready for use.
MN-948
13