Operation; Bluetooth Pairing - Air Lift Performance 3P Installation Manual

3H/3P User Guide

Operation

RISE-ON-START
This setting brings the vehicle to ride height
at key-on if below ride height.
1. Off (default)
2. On
PRESET MAINTAIN
When enabled, the Preset Maintain will maintain
the selected preset, whether pressure or height.
1. Off (default)
2. On
MINIMUM DRIVING HEIGHT
Set the minimum vehicle ride height. The system
will not deflate below this level while driving.
1. 0-100 PSI (pressure mode) or 0-100%
(height mode)
2. Hold down the up or down button to
cycle quickly to 0 or 100 PSI or press the
buttons individually to go up or down 1 PSI at a time.
3. 25 PSI (pressure mode) or 25% (height mode) (default)
PRESSURE/HEIGHT MODE
Set system to operate in height or pressure mode.
1. Height
2. Pressure (default)
ANTI CROSS-LOAD/AXLE EQUALIZATION
Set system to equalize the axle to prevent cross-loading.
1. Off
2. On (default)
SHOW MODE
This provides operation with ignition off for one ignition cycle.
(Running compressor will drain the battery.)
1. Off (default)
2. On

BLUETOOTH PAIRING

Set to "on," to enable Bluetooth pairing with a compatible mobile device
for one ignition cycle. If no display is present, pairing mode can be entered
by: turning the ignition on 3 seconds, ignition off 3 seconds, ignition on.
MN-948
9