Air Lift Performance 3P Installation Manual page 12

3. Display
4. Height sensor harness (optional)
5. Reconnect the battery once the system is completely installed.
NOTE
Keep proper drip loops and use proper bend radius for wire bundles (fig. 9).
* FL = Front left corner
FR = Front right corner
RL = Rear left corner
RR = Rear right corner
8
• Route the main harness display cable as desired to the preferred operating location.
• Attach the 4' display cable to the main harness cable, and to the back of the display.
• Route and attach each height sensor harness to the height sensor locations based
on the heat shrink labels for the appropriate corners of the vehicle (FL, FR, RL, RR)*.
• Connect the main harness height sensor drops to the appropriate height sensor
harness feeding the corresponding corners of the vehicle (match FL, FR, RL, RR)*.
Route for potential
water intrusion
Installation Manual
fig. 9
MN-946