Installing Air Lines - Air Lift Performance 3P Installation Manual

Installation Manual

INSTALLING AIR LINES

1. Route and attach the air lines from the manifold to the air springs and from the manifold
2. Attach air lines to the appropriate manifold ports for the air springs, filter/tank and
NOTE
Air lines should be pushed in firmly, with a slight back-and-forth rotational twist – check the
connection by pulling on each line to verify a robust connection.
3. Exhaust port can be left open, or routed to preferred exhaust location. Routing exhaust
NOTE Use the included hose cutter (Part number: 10530). Cut all hose ends as squarely and as
smooth as possible (fig. 10).
NOTE To release the air line from the connection (fig. 11), first release all air from the system.
Push on the line (step 1), depressing the ring towards the fitting (step 2), and then pull the
hose out of the fitting (step 3).
HELPFUL AIR LINE TIPS
4. Minimum hose bend radius
5. Hose to fitting
6. Hose cutting
MN-946
to the filter, as well as from the filter to the tank, if not mounting filter directly to tank.
• Route air lines free from abrasive edges and heat sources.
exhaust.
outside of vehicle will eliminate any possibility of moisture being discharged from the
port to surrounding area.
GOOD CUT
• 3/8" hose = 1.5" hose bend radius.
• 1/4" hose = 1" hose bend radius.
• No side loading on fitting from hose.
• Hose straight for 1" before bending.
• Cut hose perpendicular to hose length.
• Inspect hose for scratches that run lengthwise on hose prior to insertion.
• Use the included hose cutter.
POOR CUT
STEP 1
STEP 2 STEP 3
fig. 10
fig. 11
9