Introduction; Important Safety Notices - Air Lift Performance 3P Installation Manual

Introduction

The purpose of this publication is to assist with the calibration, maintenance,
and troubleshooting of the Air Lift Performance 3P or 3H control systems.
Read the entire user guide before beginning calibration or performing any
maintenance, service or repair. The information includes a step-by-step
calibration set-up, display options and functions, and diagnostic troubleshooting.
Air Lift Company reserves the right to make changes and improvements
to its Air Lift Performance products and publications at any time. For the
latest version of this manual, contact Air Lift Company at (800) 248-0892
or visit www.airliftperformance.com.

IMPORTANT SAFETY NOTICES

WARNING
need to turn the key on in the vehicle for any reason.
WARNING
no person or thing is near or in the way of the vehicle's path of travel while
cycling the suspension.
WARNING
user or vehicle, Air Lift Company strongly recommends not to change this
value. If for some reason the minimum drive height is set below the default
value, Air Lift Company suggests this setting only be used while the vehicle
is stationary. It is possible to set the vehicle at a height that is below this
threshold, then start driving. This is a universal system and settings will be
different for every user and vehicle. The installer is responsible to determine
how low the suspenion can be set without causing damage. It is the sole
responsibility of the user, and Air Lift Company will not be held liable for,
anything that may happen to the operator or the vehicle as a result of the
user's choice to alter these default values below recommended minimums.
WARNING
about where to place the jack. Before raising the vehicle, place wheel
chocks in front and behind the wheels to prevent them from rolling. Always
use jack stands to support the vehicle. Never get under or place any body
parts under a vehicle that is solely supported by the jack.
4
Before servicing the vehicle, make sure to turn
off "rise on start" and "preset maintain." This will
eliminate any unintended suspension cycling if you
Only use the Air Lift Performance 3 App on a mobile
device when the vehicle is in a clear line of sight. To
avoid the risk of serious injury or harm, verify that
For user safety and to prevent vehicle damage, the
system has a 25% or 25 PSI minimum drive height
as the default. Due to extreme risk of danger to the
Floor jacks can be dangerous. Whenever using a
floor jack, make sure it is rated for the load it is lifting.
Check the vehicle owner's manual for information
3H/3P User Guide
MN-948