Korg GEC3 User Manual page 58

Group Mode
Figure 13
2. Select the group you want the student to belong to.
OR
Select GR.OFF if you do not want the student assigned to a group. (You can use this
setting if it is not appropriate for that individual to be assigned to a group and you want
them to work independently.
3. Once you have made your selection, press BACK to close the screen.
The group you selected will appear on the top right corner of the student group box.
4. Repeat steps one thru three until you have assigned each student you wish to the group.
Note:
If you are using the Expansion Unit, each unit of 16 students works independently; you cannot
group students from one set of 16 with students from another set of 16. For example, you
cannot group a student in keyboard group 5 with a student from keyboard group 17.
5. When you are finished, begin assigning students to the next group.
6. Once you have assigned all students to groups as desired, press BACK to close the
screen.
The students are now ready to work in Group mode.
How to load and customize a (pre-set) group
1. Load a preset group (see the procedure How to load group info, in this chapter for
directions) Duet or Quartet.
2. Make any changes by adding students to the existing groups or by moving students from
one group to another (see the procedure How to assign a group, in this chapter for
directions).
58