Korg GEC3 User Manual page 40

Class & Teacher Preferences, Class Setup
this:
5. Press a student's keyboard group in Setup mode to bring up the QWERTY Keypad.
6. Use the QWERTY keypad to enter in each student's name into the Student Name field.
See the section QWERTY Keypad in Basics for instructions on how to use the keypad.
7. Close the QWERTY Keypad after you finish entering each student, and start the procedure
again for each student name you are entering.
Note:
When not using the Split Feature, you can use the whole Student Name field to enter the
student's name. When you are using the Split Feature, the vertical line indicates where
Student A ends and Student B begins. Make sure to use only the allotted space for each
student. If student A's name is shorter than the allotted space, use the space bar to space over
to Student B's space
8. Press Disk to open the Disk tab.
9. Press Save Global Setup to save changes.
Repeat the procedure for each class you need to setup.
You are now ready to use the GEC3 for instruction in a class setting. Read through the
following chapters to understand the functionality and features available to you in each mode.
40