How To - Korg GEC3 User Manual

How to...

Open a Class (from which to view or edit student names)
All assigned student names are associated with a class. To bring up a class, you must first
assign that class a name using the Class Selection and Edit screen. Prior to viewing or editing
student names on this screen, open the class you wish to view or modify using the following
procedure. If you choose not to assign a class name, skip to the View or Edit a Student's
Name procedure)
1. Open the Global tab, by pressing Global from the row of tabs at the bottom of the screen.
2. From the Teacher field, select the teacher name that is associated with the class you want
to open. All the classes associated with the teacher will now be available from the Class
field.
OR
If desired teacher name is not listed, add the teacher name using the Edit Teacher
Information screen, described in the Global chapter.
3. Select a class name from the Class field.
View or Edit a Student's Name
1. Press a student's keyboard group in Setup tab to bring up the QWERTY Keypad.
2. Use the QWERTY keypad to enter each student's name into the Student Name field .
3. Close the QWERTY Keypad after you finish entering each student, and start the procedure
again for each student name you are entering. See the section QWERTY Keypad in Basics
for instructions on how to use the keypad.
Note:
When not using the Split Feature, you can use the whole Student Name field to enter the
student's name. When you are using the Split Feature, the vertical line indicates where
Student A ends and Student B begins. Make sure to use only the allotted space for each
student. If student A's name is shorter than the allotted space, use the space bar or the scroll
arrow to space over to Student B's space.
5. Press Disk to open the Disk tab.
6. Press Save Global Setup to save changes.
Lecture Mode
45