Power On; Mode Buttons; A, B And A+B Buttons - Korg GEC3 User Manual

Meet the GEC3

Power On

When you press the On button, the GEC3 logo appears while the unit performs self-test. It
looks like this:
All student units are tested and reported with on of the following symbols:
O – for "OK" if all SI units are connected.
X – for "Error" if not all SI units are connected.
If any of the units fail self test, the screen is visible until the teacher presses the screen. After
power on, the GEC3 automatically loads the first teacher and class setup.
If an expansion board is in use, it is automatically detected and all additional student boxes
are tested, or the "#17-32: not present" message appears.
If you experience problems during the Startup procedure, review the Installation process to
make sure you installed the system properly, or, contact your system administrator or Korg
representative.

Mode Buttons

The mode buttons are the three buttons to the right of the screen display. Press a mode button
to select the corresponding mode (Lecture, Practice and Group). The various modes are
described in the Overview section of this manual.

A, B and A+B Buttons

These are the three buttons below the screen display. They are used when you are using the
Split Feature and need to monitor a student. When you are using the Split Feature, press A or
B, then the keyboard group, to monitor the A or B student in that keyboard group.
14