Figure 4.6-3
Figure 4.6-4
Figure 4.6-5
Page 4.6
RUN EXCITE: Service & Maintenance Manual - rev. 1.5
1. Turn off the machine and unplug the mains
lead from the wall outlet.
2. Back off the 2 screws a on either side of the
machine using an 8-mm hex T-wrench.
3. Remove the plastic cover b.
4. Working on the right side of the machine,
unplug the two connectors c behind the cover
b.
5. Remove the entire mach
pulling it upward.
6. Remove the m
otor guard.
7. Insert cable 7
, TRM-46, into the hole at the
base of the left machine column, in the
direction indicated by the arrow, until it
comes out of the top.
8. Fit the rubber cable holder 8 into the column,
to protect the antenna cable.
Continued on following page →
ine control panel,