Technogym Run Excite 500 Service Maintenance Manual page 136

Figure 7.2-13
Figure 7.2-14
Figure 7.2-15
Page 7.6
RUN EXCITE: Service & Maintenance Manual - rev. 1.5
2. Pull the connector out of its seat and unplug
the connector indicated in the figure.
3. Disconnect the connecto
figure, on the LVDS board, on the LCD
inverter of the keyboard and of the
headphone jack.
4 . Back off the 11 screws indicated in the
figure, that are fixing t
circuit boards to the front display covering.
5. Remove the display plate from the front
covering.
6. Back off the 2 screws q using
screwdriver.
7. Back off the 2 screws r using a small Philips
screwdriver.
8. Remove the LCD.
To reassemble the LCD and the circuit boards,
carry out the above steps in reverse order.
rs p indicated in the
he plate with the
a small Philips