Technogym Run Excite 500 Service Maintenance Manual page 101

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Replace the digital
plan board
It mi gh t also be
logi c, p rovided i
Foll ow th e pr oce re s du
che cks h ighlight ed by c
Place the tester pr
(1)
app roxima tely 220
As for step (1 ) but
(2)
As for step (1 ) but
(3)
Pla ce the test er p
(4)
approximately 11.
As for step (4) but
(5)
Place the tester pr
(6)
Th e measu red val
As f or step (6) but
(7)
As f or step (6) but
(8)
As for step (6) but across terminals 9 and 12 of patch connector F.
(9 )
(10) As for step (6) but across pins 4 and 6 of patch connector CN9 on the digital plan board.
NO
Is the emergency signal at the
output of the digital plan board
helpful to refer to the theoretical explanation of the emergency stop
n paragraph 3 .4. "Emergency stop management"
t ep by step to correctly diagno
ircled numbers, which are described in detail below:
obes across pins L1 and L2 of the inverter. The measured voltage should be
VAC.
across terminals 2 and 6 of the
across terminals 4 and 8 of the re
robes across pins 0 and 1 of the relay. The measured value should
7 Vdc.
across the R+ and R- terminals of the elevation + cutout board.
obes across pins 2 and 3 of connector X4 on the elevation + cutout b
ue should be approximately 0 Vdc.
across terminals 9 and 12 of connector X2 of the download board.
across terminals 9 and 12 of connector X1 of the download board.
B
10
YES
correct?
se the problem. Take particular care with the
relay.
lay.
Replace cable TRM-20
oard.
Page 6.33
be