Technogym Run Excite 500 Service Maintenance Manual page 163

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Figure 7.17-6
Figure 7.17-7
Figure 7.17-8
11. Remove the drive-belt
from the motor pulley.
12. Back off the two screws i of the system
which limits the range of motion of the
running track at the front, using a 5-mm hex
wrench.
During reassembly, lock down the
screws using i torque wrench set for 9
Nm.
13. Back off the 4 screws j (there will be another
2 on the front, if the machine does not
incorporate the system shown in Figure
7.17-7), which secure the running deck to the
frame, using a 6-mm Allen wrench.
14. Remove the running deck from the side.
During reassembly, lock down the
screws using "j" torque wrench set for
20 Nm.
Continued on following page →
h by pulling it away
Page 7.33