RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Figure 7.2-4
Figure 7.2-5
LED Board c:
1. Remove the Digi
tal Plan board as described
in the previous procedure.
2. Back off the 5 screws e using a medium
Phillips s
crewdriver.
3. Remove the circuit board from the display.
To reassemble the circuit boards, carry out the
abo
ve steps in reverse order.
Before reassembling the display, fix the
ferrite to the TRM-23 cable's connector,
by means of two cable ties "f" as in the
figure at left.
Page 7.3