Technogym Run Excite 500 Service Maintenance Manual page 135

RUN EXCITE: Service & Maintenance Manual - rev. 1.5
Figure 7.2-10
Figure 7.2-11
Figure 7.2-12
Connectors board c:
1. Disconnect the antenna cable
splitter.
2. Back off the 4 screws i using a small Philips
screw driver.
3. Rem ove the board from the display, taking
care not to damage the connector that
connect it to the C
L VDS board d:
1 . Disconnec t the cables l indicated.
2. Back off the 4 screws, that fixing the board
to the display plate, using a small Philips
screwdr iver.
3. Remove the L VDS board.
CPU board e
1. Disconnect the cables indicated in the figure,
coming from LVDS boar
keyboard and headphone ja
2. Disconnect the splitter / amplifier device m,
from the tuner.
3. Back off the screws n using a sm
screwdriver, included the one covered by the
splitter and remove the CPU board.
To disassemble the LCD:
1. Back off the 2 screws o that are fixing the
headphone jack, using a small Philips
screwdriver.
Continued on following page →
h going to the
PU board.
d, LCD inverter,
ck.
all Philips
Page 7.5