Figure 7.17-9
Figure 7.17-10
Figure 7.17-11
Page 7.34
RUN EXCITE: Service & Maintenance Manual - rev. 1.5
When reassembling the running deck,
remember to insert the plastic bushing
and the washer "k" on
supports.
To disassemble the shock absorbers:
15. Back off the 8 screws l securing the shock
absorbers to t
he frame using a 4-mm Allen
wrench, accessing it from below.
On
newer
absorbers are not secured with screws,
but affixed directly to the frame with
double sided tape.
16. Fully back off the screws which release the
tension of the rear roller.
17. Remove the rear roller from the top as
indicated by the arrow.
18. Remove the tread belt.
To reassemble the various components, carry out
the above steps in reverse order.
At the end of the procedure, checking
the alignment of the motor drive-belt,
the tension and alignment of the tread
belt and the height adjustment of the
running deck
the rear
machines,
the
shock