Table of Contents
Advertisement
Introduction
INTOODUCTION
The B2800 flow monitor is a state-of-the-art digital signal processing flow monitor, designed to provide exceptional flexibility
at an affordable price Though it is designed for use with Blancett flow meters, this display can be used with almost any flow
meter producing a low amplitude AC output or contact closure signal
This flow monitor is capable of accepting a low level frequency input for calculating flow rate and total These calculations can
then be displayed in a variety of units of measurement The monitor's large eight digit by 0 50 in (12 7 mm) numeric liquid
crystal display makes extended range viewing practical The second eight digit by 0 25 in (6 35 mm) alphanumeric display
provides for selectable units viewing in run mode and prompts for variables in program mode The display can show rate,
total or alternate between both rate and total
Figure 1: B2800 Panel mount flow monitor
INSTALLATION
1 Cut a 3 6 in × 3 6 in (9 144 cm × 9 144 cm) square opening in the panel See
Figure 2
2 Disconnect the battery from the main board terminal
3 Remove the large battery mounting plate by removing the four Phillips head screws from the main assembly standoffs
4 Mount the main assembly through the panel opening and temporarily hold in place (tape will work)
5 Attach the signal wires to the appropriate terminal blocks
6 Reattach the large battery mounting plate with the four Phillips head screws
7 Secure the assembly to the panel with the four outer screws
3.6 in
(9.144 cm)
3.6 in
(9.144 cm)
Figure 2: Panel cutout
Page 4
DSY-PM-00278-EN-04
November 2017
Advertisement
Table of Contents
