Class 0X67 (Extended Object Ii) - Mitsubishi Electric FR-A8ND Instruction Manual

7.2.9

Class 0x67 (Extended object II)

 Class 0x67 Instance 1
Set parameters of the inverter. The data type of each attribute is UINT, and the size is 2 bytes.
The usable parameters depend on the inverter. Refer to the instruction manual (Detailed) of the inverter of the parameters.
NOTE
• For parameter writing or reading, Class 0x70 to 0x79 (Extended object III) is recommended. (Refer to
[Attribute]
Class 0x67 Instance 1
Attribute
Pr. Access
ID
10 Pr.270 Get/Set
11 Pr.271 Get/Set
12 Pr.272 Get/Set
13 Pr.273 Get/Set
14 Pr.274 Get/Set
15 Pr.275 Get/Set
16 Pr.276 Get/Set
18 Pr.278 Get/Set
19 Pr.279 Get/Set
20 Pr.280 Get/Set
21 Pr.281 Get/Set
88
OBJECT MAP
Name
Stop-on contact/load torque high-
speed frequency control selection
High-speed setting maximum
current
Middle-speed setting minimum
current
Current averaging range
Current averaging filter time
constant
Stop-on contact excitation current
low-speed multiplying factor
PWM carrier frequency at stop-on
contact
Brake opening frequency
Brake opening current
Brake opening current detection
time
Brake operation time at start
Class 0x67 Instance 1
Attribute
Pr. Access
ID
22 Pr.282 Get/Set
23 Pr.283 Get/Set
24 Pr.284 Get/Set
25 Pr.285 Get/Set
26 Pr.286 Get/Set
27 Pr.287 Get/Set
38 Pr.338 Get/Set
39 Pr.339 Get/Set
40 Pr.340 Get/Set
41 Pr.341 Get/Set
42 Pr.342 Get/Set
page 90)
Name
Brake operation frequency
Brake operation time at stop
Deceleration detection function
selection
Overspeed detection frequency
(Speed deviation excess detection
frequency)
Droop gain
Droop filter time constant
Communication operation
command source
Communication speed command
source
Communication startup mode
selection
RS-485 communication CR/LF
selection
Communication EEPROM write
selection